Industrial Water Chiller For CNC/Laser Engraver 110V. CW-3000 Series is professional cooling machine referring to international, advanced thermolysis cooling system design, suitable for small water-cooled cooling devices requested machinery. Specific disconnection alarm security protection. Hermetic type water tank, water is available for a long time used.
Real-time temperature monitoring, accurate knowledge of heating devices working condition. Professional air-cooled forced radiator with strong heat dissipating capacity and difficult to be blocked up. Equipped with alarm output port to protect sensitive components quickly. High cost performance, low failure rate. Outside dimensions 10mm brass connector.
It is strictly forbidden to plug and run the cooler without feeding water. Cooler should be placed in a well-ventilated, dry environment place and away from heat sources. Please keep at least 30cm from obstructions to the air outlet which is in the back of the cooler, and should leave at least 10cm between obstructions and air inlets of two sides. The cooling water must be drained if the cooler is out of use for long time or before being transported. To protect laser tubes , the radiator fan of cooler will suspend to work when water temperature is lower (about 10) , and it will restart to run when water temperature rises to higher (about 20).
The first Installation It is very simple to install this industrial cooling machine. The first time installation of the new machine can be carried out by following steps. Open the package to check if the machine is intact and all the necessary accessories are completed. Open the injection port, then add cooling water.According to system conditions, connect the water inlet and outlet pipe well. Plug in power, turn on the power switch. (Do not allow the water overflow) 5. Check the water level of the water tank again.
(It should be 80-150cm from the surface of water to the injection port). To ensure good heat dissipating, please open the lid to clean the dirt after the cooler used in long-term.Working in cold north area, it is better to use noncorrosive antifreeze fluid. Orders are processed from Monday-Friday; Not on the weekends & public holidays. We will work with you to get the case resolved in the fastest method. Please contact with us at first for more details. Defective & Damaged Products If product was received damaged or not as described, please send us some pictures or videos, so we could well understand your problem, then solve them for you ASAP.
Besides, it's much helpful for us to claim with UPS, remind our related department to pay much more attention to packaging later on. If an item is received damaged, customer service must be contacted within 7 days of receiving your item. ECheck Issues: Payments via eCheck do not clear immediately. Usually you will wait 5-7 days after checkout for it to clear. The item "Industrial Water Chiller For CNC/Laser Engraver Engraving Machine 110V Premium" is in sale since Tuesday, May 5, 2020.
This item is in the category "Business & Industrial\HVAC & Refrigeration\Other HVAC & Refrigeration". The seller is "ascprinting" and is located in Scarborough,Ontario. This item can be shipped to Canada, United States.